Solutions /
Spark Detection

The spark detection and fire extinguishing system works faster than the explosion

The spark detection and fire extinguishing system is designed to stop ignition sources from getting into dust explosion hazardous areas, such as silos and filters. Extremely fast and sensitive spark detectors detect ignition sources in a millisecond and start the water extinguishing. The extinguishing normally lasts for 5 seconds and stops automatically.

Our customers include companies that work in wood, bioenergy, recycling, paper, food, textile and fibre-reinforced plastic industries. Atexon products are ATEX certified by Eurofins Expert Services ltd. and they also conform CEA regulations.

More information:

+358 (0)10 325 3581
info@atexon.com

Advanced Spark Detection Technology – Atexon V300EX

The patented V300EX spark detection family offers supreme detection technology for fast fire prevention. The extra wide field of view and detection spectrum and daylight filter make it possible to use the detector in even a wider range of working conditions.

Properties:

– 180° field of view
– Detects light-emitting sparks
– Detects coal heat even under 300 °C
– Low and protected lens construction
– ATEX approved model for zone categories 20, 21 and 22
– Model VF300EX includes a daylight filter

V300EX leaflet

V300EX Spark detector. Ultrawide detection angle and detection spectrum.

Advanced Spark Detection Technology – Atexon V300EX

The patented V300EX spark detection family offers supreme detection technology for fast fire prevention. The extra wide field of view and detection spectrum and daylight filter make it possible to use the detector in even a wider range of working conditions.

Properties:

– 180° field of view
– Detects light-emitting sparks
– Detects coal heat even under 300 °C
– Low and protected lens construction
– ATEX approved model for zone categories 20, 21 and 22
– Model VF300EX includes a daylight filter

V300EX leaflet

V300EX spark detector with extra wide viewing angle and detection spectrum

Mounting principle of the spark detection and fire extinguishing system

1. The spark detectors detect the ignition sources in a millisecond.
2. The extinguishing unit extinguishes sparks and embers with a small amount of water.
3. The signal router guides and monitors the extinguishing event.
4. The VR18Z control panel monitors the whole system.
5. The signal device gives alarms using a siren and a strobe light.
6. The blower controller stops the blowers in case of overheating or a spark shower.
7. The overheat sensing cable monitors the blower bearings and the blower perimeter.
8. The pressure booster controller guides the water pump and the heat tracing cables
9. The pressure booster ensures airless extinguishing water with correct pressure.

Read more:

IEP-Technologies Spark Detection and Extinguishing System Brochure, English US
General brochure about Atexon spark detection and fire extinguishing systems. PDF-file, updated on 6th May 2019.

Other language versions

Atexon® fire extinguishing systems are extremely reliable. We have protected over 2,500 targets against dust explosions. View our references